Hmmh, no, not really: I import route A, start naviagtion mode, then switch off navigation mode, tilt the map and choose a ceratin zoom mode (e.g. 2km, follow mode). At this point switching navigation mode on/off restores my settings every time (like exspected). Always “tilt, 2km zoom, follow mode”.
Then I import route B, route is shown completey (tilt is off now, zoom factor adjusted, e.g. 20km, follow mode was preserved).
Now I start navagation mode again. After switching this mode mode off, tilt and zoom settings are restored like they were after importing route B (tilt off, 20km). But I would expect my former “navigation switched off”-settings I adjusted while using route A (which means in this example: tilt off, 2km zoom, follow mode).
This way I would be able to adjust settings I always want to use if switching navigation mode off.
This is what I tried to express: tilt off and zoom factor to be able to view the whole route after importing it is Ok. But switching back from navigation mode should use tilt/zoom seetings like they were set the last time I switched back from this mode, not like they were after importing a new route.