I created and followed a round trip, but sometimes the voice instructions say turn left, but the map shows I have to turn right, and vice versa.
Then at another point, the map shows to go backwards and forwards repeatedly traversing a road for some reason.
As for re-routing when going off-route, I have found it loses its location and gives up on re-routing.
I have set to offline routing, and ticked rerouting as it says in the feedback.
It contains start, end and a turn instruction in the middle, which asks you to turn left. If you follow this route from start to end all is good. If, however, you decide to leave the route and rejoin from, e.g. “Pfarrhofener Strasse” as shown in this screen shot:
you might still get the announcement to turn left even though this is wrong from the drivers perspective. This happens to me frequently. I have learned to live with this though as you can easily see the correct direction on the display anyways.
I know. That’s fine. This is why I mentioned that I usually have re-routing turned off.
Yes, I understand that. The only thing you could do here is to ignore turn instructions in the vicinity of where the driver rejoins the route. But - as I said - not an issue for me as I can look at the display.
Not allowed to upload the route file because I’m a new user. You would have seen at Via Point 2 the map says turn right on to School Hill, but the turn instructions say turn left.
Is there another way to upload route files?
Also, missed the route later on and all it said was “missed route” and didn’t even try to reroute. Left me without any directions - scary.
Look at Point 1 near Calvert - this is where the directions contradict the map.
I do have rerouting enabled, but it still doesn’t do so.
Also at one point, it tried to take me on to a road that was marked “not suitable for motor vehicles”. I ignored it and it said “missed route” but didn’t offer any directions to get back on track.