And what then about the minorities? This would only make sense, if any option has NO proponents at all.
Not to be expected.
But perhaps better outsource this fundamental question, how to deal with multiple “necessary or unnecessary” options and the “overloading” with possible options, in another thread?
sounds good, not yet available on my device, probably takes a while… but I have another question:
since 1.13.2 it should work to rename Waypoints and switch between regular and shaping. This is not working for me. Nothing happens when I long-press on a waypoint (still 1.13.5).
When long press on (yellow) via points or (white) shaping points, their dialog appears with different actions per type. The via points offer the “Edit” action to rename them.
Long press menu on waypoints works if enable the “Settings | Map | Crosshair placement”.
Hi. Yesterday I tried Strict navigation mode on our 360 km trip. Everything works as expected
But, after one pause on route, I turn navi on again and it starts to beep after every instruction. I was on route and I have Off route warning disabled. I’ve never seen this behavior…
Do you mean that you stopped completely navigation and started it again?
Then obviously it understands that you are not following the route “strictly”,
but started navigation on a random point along the route, in flexible mode.
With strict navigation, cannot start navigation anywhere after 1st waypoint.
You can skip all waypoints before your location for strict navigation to work.
“Navigate along the route without shortcuts, i.e. follow the route strictly from one waypoint to another. When go off route, the rerouting tries to resume to the last omitted waypoint.”
Yes, we reached one of waypoints, where I stopped navigation and after break I started navigation again. I did this at every waypoint but beeps started only after last one.
I think @devemux86 meant, that the source of the beeping may have been something else - not Kurviger
Edit:
Some time ago I had a similar experience caused by a weak bluetooth connection. (low battery)
is it possible that there are currently only two options for route recalculation?
“next waypoint and strict navigation”
I have now tried several times to drive a round trip with a detour. As soon as the recalculation starts the whole tour is gone, from 280 km it is only 14 km to the finish. My route has only 2 waypoints, one where the entrance stands and once refueling after about 120 km… It doesn’t matter if online or offline (BRouter).